CipherLab 1662 L - Continuous Mode (1662 L Only); Alternate Mode (1662 L Only)

42
Enter Setup
1662 L/1664 Barcode Scanner User Guide
1.7.6 CONTINUOUS MODE (1662 L ONLY)
The scanner is always scanning.
 After a successful decoding, the removal of barcode is required. It is not allowed to
proceed to decode until the decoding delay time has passed.
 To decode the same barcode repeatedly, move away the barcode and put it back
again and again for scanning.
Note: Refer to “Delay between Re-read”.
Continuous Mode
Decoding Delay
Set the time interval between each decoding.
*Disable
0.5 sec
1 sec
2 sec
1.7.7 ALTERNATE MODE (1662 L ONLY)
The scanner will start scanning once the trigger is pressed
 The scanning won't stop until you press the trigger again.
Alternate Mode