Need help?Do you have a question about the CipherLab 1504 and is the answer not in the manual?
General| Type | Handheld |
|---|---|
| Scanning Technology | Linear Imager |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
| Connectivity | USB, RS232, Keyboard Wedge |
| Operating Humidity | 5% to 95% (non-condensing) |
| Drop Spec | 1.5 m (5 ft.) |
| Resolution | 4 mil |
| Supported Barcodes | UPC, EAN, Code 39, Code 128, Codabar, Interleaved 2 of 5 |
| Power Supply | 5 VDC ±10% |
| Light Source | 630 nm visible red LED |
Information regarding US and Canadian regulatory compliance for the device.
Guidelines for safe operation, laser safety, and scanner upkeep.
Lists the items included in the scanner package.
Highlights the key capabilities and advantages of the barcode scanner.
Covers entering/exiting configuration mode and setting defaults.
Explains how to configure parameters using setup barcodes.
Instructions for listing and checking the scanner's current configurations.
Method for creating simplified configuration barcodes.
Details on Power, Buffer, LED Indicator, and Beeper feedback.
Explains Scan Modes, Timeouts, and Read Redundancy.
Covers Auto-Sense, Negative Barcodes, Cable Auto-Detect, and Picklist Mode.
Configuration for using the scanner as a keyboard input device.
Setup for communicating via a serial port.
Configuration for USB Human Interface Device connection.
Setup for scanner communication via USB Virtual COM port.
Settings for Codabar, Code 25 variants, Code 39 variants, Code 93, Code 128, MSI, EAN/UPC, etc.
Configuration options for GS1 DataBar (RSS Family) barcodes.
Settings for postal codes and various 2D barcode types.
Covers Letter Case, Character Substitution, and Prefix/Suffix Code settings.
Options for assigning Code IDs and Length Codes to symbologies.
Settings for Multi-Barcode Editor and Special Character Removal.
Procedure to remove specific characters from scanned data.
How to enable and apply configured editing formats.
Steps for defining data criteria, fields, and transmission sequences.
Practical examples demonstrating data editing format configurations.
Instructions for updating firmware using a serial connection.
Instructions for updating firmware using a USB connection.
Reference for serial commands to control scanner functions and settings.
Defines key mappings and status for Keyboard Wedge and USB HID interfaces.
Provides Decimal, Hexadecimal, and ASCII table references for data input.
Configuration for reading and parsing driver's license data.
Arranging license data fields and defining separators.
Creating and editing additional fields for license data.
To Next Page
