29
Update
Chapter 1
Understandin
he Barcode Scanner
1.11 AUTO-SENSE MODE
This mode is only available when seat the scanner in the Auto-Sense Stand. Enable this
mode, it will force the scanner to apply Laser mode as the scan mode. However, it works
slightly different from the original Laser mode. Now the scanner will be expecting
barcodes as long as it is seated in the Auto-Sense Stand, as shown below. Whenever a
barcode is brought within range, the scanner will be able to decode it.
Refer to
1.6.7 Presentation Mode.
Note: To stop this mode, remove the scanner from the stand or have the scanner read
the “Disable (Auto-Sense)” barcode below. It will return to Laser mode. If Laser
mode is not desired, proceed to select a scan mode best suits the application.
Enable
*Disable
1.12 NEGATIVE BARCODES
To Next Page
Loading...
Need help?
General
