73
Chapter 3 System Menu
3.11.3 WLAN SETTING
Wireless networking can operate in two modes – (1) Ad-hoc mode: peer-to-peer, and (2)
Infrastructure mode: point to multi-point through access points.
Set the following parameters.
Local Name
Enter a name for identifying the mobile computer.
By default, it is made up of model number and the serial number.
SS ID
This refers to Service Set Identifier or AP name, which is used for remote device association.
The mobile computer can ONLY communicate with access points that have the same SS ID.
System Scale
This refers to Access Point Density.
Options — [1] Low [2] Medium [3] High [4] Customized
The value you set must match that set for the access point.
“Low / Medium / High” means the mobile computer will search for other APs only when data
transmission rate drops below “1 / 2 / 5” Mbps individually.
Customized” lets you set data rate for the mobile computer to search for other APs when data
transmission rate drops below the specified value —
802.11b: 1, 2, 5.5, 11 Mbps
802.11g: 1, 2, 5.5, 11 Mbps & 6, 9, 12, 18, 24, 36, 48, 54 Mbps
Power Saving
This refers to the low power consumption mode.
Options — Enable or Disable
The value you set must match that set for the access point.
Preamble
Options — [1] Long [2] Short [3] Both
The value you set must match that set for the access point.
To Next Page
Loading...
Need help?
General