Select Automatic, 5 GHz only, or 2.4 GHz only
for your Wi-Fi frequency band. The default
setting is Automatic.
Select whether to enable Wi-Fi roaming or not.
The signal strength when triggering Wi-Fi
roaming. The higher value means the sensitivity
of triggering roaming is higher.
The qualification for roam candidates. The
higher value means the signal strength of
candidate APs should be higher than the current
connected AP.
Enables your device to connect with a Wi-Fi
Direct-capable device.
Displays the MAC address of the device when
connecting to Wi-Fi networks.
Displays the IP address of the device.
To Next Page
Loading...
Need help?
General
