Circutor computer MAX 12 - User Manual

INSTRUCTION MANUAL
Power factor regulators
computer MAX 6 / computer MAX 12
(M98228201-03-17A)

Circutor computer MAX 12 Specifications

General

Brand	Circutor
Model	computer MAX 12
Category	Controller
Language	English

Summary

Safety Precautions

Verification Upon Reception

Introduction and Safety Recommendations

2.1. Safety

Safety precautions for installation, maintenance, and operation, highlighting risks and protective measures.

Product Description

Device Installation

4.2. Connections

Provides instructions and warnings for device connections, including safety notes and CT requirements.

Operation

5.3. Errors and Error Messages

Details error codes, meanings, and potential causes for device malfunctions, aiding in troubleshooting.

5.5. Regulator Status and Key Functions

Describes operating statuses (RUN, Set-up) and the functions of device keys in each mode.

Configuration

6.1. Configurable Parameters

Covers parameters needing setup for regulator adaptation to loads and installation requirements.

6.1.1. Plug&Play Function

Details the automatic parameter detection process for initial setup, including operational conditions.

6.1.2. Cos Target

6.1.3. Smaller Available Capacitor Step

6.1.9. Programming the CT Rated Current (Primary)

Sets the primary rated current of the CT for accurate installation current measurement.

6.2. Set-up Menu and Procedure

Run Status

7.1. Functions of the Device in Normal Run Mode

7.2. Computer MAX Behaviour in Alarm Mode

Explains device behavior and error display when alarm conditions are detected.

Technical Features

Maintenance and Technical Service