41
Instruction Manual
CVM-C4
oFF, relay output 1 is disabled.
rEn, remote control output.
ALr, alarm output.
With a long keystroke, press to validate the option.
Use the keys and to browse through the menu screens.
6.3.2.- RELAY PULSE DURATION
Note: Visible variable if the relay operating mode has been configured as a remote control output or
alarm output.
The alarm relay can behave in 2 different ways:
1 .- The relay is activated when the alarm is triggered and is deactivated when the alarm is
deactivated.
2 .- The relay is activated when the alarm is triggered and is deactivated after a programmed
period of time, even though the alarm condition has not been cancelled.
This screen is used to configure the programmed time, i.e., the relay pulse duration.
To make the relay operate in mode No. 1, program the value to 0.
do-1
tinE
0000
>3s
do-1
tinE
0000
-
-
.
.
With a long keystroke (>3s), press to access the value's configuration.
Use the key to modify the value of the flashing digit.
When the desired value is shown on the screen, press the and keys to skip the digit.
Minimum configuration value: 00.00 s
Maximum configuration value: 99.99 s
With a long keystroke, press to validate the data.
Use the keys and to browse through the menu screens.
-
To Next Page
Loading...
