Circutor CVM-C4 - 6�5�6�- Light Alarm; 6�5�7�- Save Configuration

49
Instruction Manual
CVM-C4
6.5.6.- LIGHT ALARM
If the device's input voltage or current value is higher than a % of the nominal value, the device can
make the digits on the display start flashing, in the form of a light alarm.
SyS
ALr
120
>3s
SyS
ALr
120
%
%
With a long keystroke (>3s), press to access the value's configuration.
When the desired value is shown on the screen, press the and keys to skip the digit.
Minimum configuration value: 1%
Maximum configuration value: 180%
Note: If the value 0 is programmed, the light alarm will be deactivated.
With a long keystroke, press to validate the data.
Use the keys and to browse through the menu screens.
6.5.7.- SAVE CONFIGURATION
This screen is used to save the device's configuration.
SAuE
>3s
SAuE
no
With a long keystroke (>3s), press to access the value's configuration.
Use the keys and to browse through the different options:
no, to not save the configuration.
YES, to save the configuration.
With a long keystroke, press to validate the option. The device skips to the main screen of the
next configuration menu.