Circutor CVM-C4 - 6�3�6�- Connection Delay; 6�3�7�- Save Configuration; 6�4�- Relay Output 2

45
Instruction Manual
CVM-C4
6.3.6.- CONNECTION DELAY
Note: Visible variable if the relay operating mode has been configured as an alarm output.
This screen is used to configure the alarm connection delay
do-1
dELy
0000
>3s
do-1
dELy
0000
With a long keystroke (>3s), press to access the value's configuration.
When the desired value is shown on the screen, press the and keys to skip the digit.
Minimum configuration value: 00.00 s
Maximum configuration value: 99.99 s
With a long keystroke, press to validate the data.
Use the keys and to browse through the menu screens.
6.3.7.- SAVE CONFIGURATION
This screen is used to save the device's configuration.
SAuE
>3s
SAuE
no
With a long keystroke (>3s), press to access the value's configuration.
Use the keys and to browse through the different options:
no, to not save the configuration.
YES, to save the configuration.
With a long keystroke, press to validate the option. The device skips to the main screen of the
next configuration menu.
6.4.- RELAY OUTPUT 2
The configuration of relay output 2 is the same as for alarm relay 1, see “6.3.- RELAY OUTPUT 1”.