Cirrus Design Section 8
SR22T Handling and Servicing
P/N 13772-005 8-29P/N 13772-005 8-29
Landing Gear
Before cleaning the landing gear, place a plastic cover or similar
material over the wheel and brake assembly.
1. Place a pan under the gear to catch waste.
2. Spray or brush the gear area with solvent or a mixture of solvent
and degreaser, as desired. Where heavy grease and dirt deposits
have collected, it may be necessary to brush areas that were
sprayed, in order to clean them.
3. Allow the solvent to remain on the gear from five to ten minutes.
Then rinse the gear with additional solvent and allow to dry.
4. Remove the cover from the wheel and remove the catch pan.
5. Lubricate the gear in accordance with the Lubrication Chart.
Original Issue
To Next Page
Loading...
