Contents
iv
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-8369-05
Warnings 2-2
Unpacking the Access Point 2-3
Package Contents 2-3
Basic Installation Guidelines 2-4
Controller Discovery Process for Lightweight Access Points 2-4
Deploying the Access Points on the Wireless Network 2-5
Access Point Layout and Connectors 2-6
Mounting Plate 2-7
Suspended Ceiling Adjustable T-Rail Clips 2-8
Opening the Access Point Cover 2-11
Mounting the Access Point on a Horizontal Surface 2-12
Mounting the Access Point Below a Suspended Ceiling 2-13
Mounting the Access Point Above a Suspended Ceiling 2-14
Mounting Access Point on a Network Cable Box 2-16
Mounting Access Point on a Desktop or Shelf 2-16
Attaching the Access Point to the Mounting Plate 2-16
Securing the Access Point 2-18
Using a Security Cable 2-18
Securing the Access Point to the Mounting Plate 2-19
Connecting the Ethernet and Power Cables 2-21
Connecting to an Ethernet Network with an Inline Power Source 2-22
Connecting to an Ethernet Network with Local Power 2-23
Rotating the Cisco Logo 2-24
CHAPTER
3 Troubleshooting Autonomous Access Points 3-1
Checking the Autonomous Access Point LEDs 3-2
Checking Basic Settings 3-4
Default IP Address Behavior 3-4
Default SSID and Radio Behavior 3-4
Enable Radio Interfaces 3-5
SSID 3-5
WEP Keys 3-5
Security Settings 3-5
Low Power Condition for Autonomous Access Points 3-6
Intelligent Power Management 3-6
Inline Power Status Messages 3-7
Configuring Power Using the CLI 3-10
Issuing the Cisco IOS Command Using the CLI 3-11
To Next Page
Loading...
