Contents
v
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-8369-05
Configuring the Access Point System Power Settings Using a Browser 3-12
Running the Carrier Busy Test 3-14
Running the Ping Test 3-15
Resetting to the Default Configuration 3-15
Using the MODE Button 3-16
Using the Web Browser Interface 3-16
Reloading the Access Point Image 3-17
Using the MODE Button 3-17
Web Browser Interface 3-18
Browser HTTP Interface 3-18
Browser TFTP Interface 3-19
Obtaining the Access Point Image File 3-19
Connecting to the Access Point Console Port 3-20
Obtaining the TFTP Server Software 3-21
CHAPTER
4 Troubleshooting Lightweight Access Points 4-1
Guidelines for Using 1130AG Series Lightweight Access Points 4-2
Using DHCP Option 43 4-2
Checking the Lightweight Access Point LEDs 4-2
Low Power Condition for Lightweight Access Points 4-6
Intelligent Power Management 4-6
Configuring Power Using Controller CLI Commands 4-7
Manually Configuring Controller Information Using the Access Point CLI 4-8
Configuring Controller Information 4-9
Clearing Manually Entered Controller Information 4-9
Manually Resetting the Access Point to Defaults 4-9
Returning the Access Point to Autonomous Mode 4-9
Using a WLAN Controller to Return the Access Point to Autonomous Mode 4-10
Using the MODE Button to Return the Access Point to Autonomous Mode 4-10
MODE Button Setting 4-11
Obtaining the Autonomous Access Point Image File 4-11
Connecting to the Access Point Console Port 4-12
Obtaining the TFTP Server Software 4-13
To Next Page
Loading...
