Chapter 4 Configuring SSL Termination
Configuring a Service for SSL Termination
4-48
Cisco Content Services Switch SSL Configuration Guide
OL-5655-01
Use the suspend command to suspend an active SSL proxy list.
To suspend an active SSL proxy list, enter:
(config-ssl-proxy-list[ssl_list1])# suspend
Configuring a Service for SSL Termination
An SSL proxy list may belong to multiple SSL services (one SSL proxy list per
service), and an SSL service may belong to multiple content rules. You can apply
the services to content rules that allow the CSS to direct SSL requests for content.
Note The CSS supports one active SSL service for each SSL module in the CSS (one
SSL service per slot). You can configure more than one SSL service for a slot but
only a single SSL service can be active at a time.
The following sections cover:
• Creating an SSL Service
• Specifying the SSL Acceleration Service Type
• Adding an SSL Proxy List to an SSL Termination Service
• Specifying the SSL Module Slot
• Disabling Keepalive Messages for the SSL Module
• Specifying the SSL Session ID Cache Size
• Activating the SSL Service
• Suspending the SSL Service
To Next Page
Loading...
