Cisco 11503 - CSS Content Services Switch Configuration Guide

Chapter 2 SSL Configuration Quick Starts
2-18
Cisco Content Services Switch SSL Configuration Guide
OL-5655-01
vip address 192.168.3.6
advanced-balance arrowpoint-cookie
protocol tcp
port 8080
url “/*”
add service ssl_serv2
active
content ssl_rule1
protocol tcp
vip address 192.168.3.6
port 444
application ssl
advanced-balance ssl
add service ssl-serv1
active
SSL Initiation Service Quick Start
If you configured an SSL initiation server entry in an SSL proxy list, Table 2-8
provides an overview of the steps required to create an SSL service for an SSL
initiation server.
Table 2-8 SSL Initiation Service Quick Start
Task and Command Example
1. Create an SSL service.
(config)# service ssl_serv1
Create service <ssl_serv1>, [y/n]: y
2. Specify ssl-init as the service type.
(config-service[ssl_serv1])# type ssl-init
3. Configure the IP address for the service. The service IP address must be the
same as the IP address specified in the SSL initiation proxy list using the
backend-server number ip address command. See the “SSL Initiation Proxy
List Quick Start” section.
(config-service[ssl_serv1])# ip address 192.168.2.3
4. Configure the service port. The service port must match the SSL initiation
back-end server port.
(config-service[ssl_serv1])# port 8080

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English