Cisco 11503 - CSS Content Services Switch Configuration Guide

Chapter 5 Configuring Back-End SSL
Configuring Back-End SSL Servers in an SSL Proxy List
5-16
Cisco Content Services Switch SSL Configuration Guide
OL-5655-01
To disable the Nagle algorithm for the TCP connection between the server and the
SSL module, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 1 tcp server nagle
disable
To reenable the Nagle algorithm for the TCP connection between the server and
the SSL module, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 1 tcp server nagle
enable
Specifying the TCP buffering for SSL TCP Connections
If the network is slow and congested, you can increase the buffer size that the CSS
buffers for a given TCP connection before shutting down the TCP window to 0.
Use the backend-server number tcp buffer-share command to set the TCP
buffering from the client or server on a given connection. The syntax for this
command is:
backend-server number tcp buffer-share rx number1|tx number2
To set the amount of data in bytes that a given connection can buffer from the
client traffic, use the rx number1 keyword and variable. By default, the buffer size
is 32768. The buffer size can range from 16400 to 262144. For example, to set the
value to 65536, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 20 tcp buffer-share
rx 65536
To reset the reset the buffer size to the default of 32768, enter:
(config-ssl-proxy-list[ssl_list1])# no backend-server 20 tcp
buffer-share rx
To set the amount of data in bytes that a given connection can buffer from the
server to the client, use the tx number2 keyword and variable. By default, the
buffer size is 65536. The buffer size can range from 16400 to 262144. For
example, to set the value to 131072, enter:
(config-ssl-proxy-list[ssl_list1])# backend-server 20 tcp buffer-share
tx 131072

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English