8-8
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3000
Figure 8-6 Routing the Codec Power Cables
Step 7 Connect the Cisco Unified IP Phone, VGA peripheral, and projector HD video cables.
Note The VGA Peripheral cable is the free-hanging cable resting in the VGA module attached to the center
Table segment.
Note If you encounter any problems with the HD Video cable that runs between the projector and the codec,
order the part number CTS-CAB-HDMI-HDMI as a replacement.
To Next Page
Loading...
