2-5
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
ACLMGR Messages
Error Message ACLMGR-3-MERGEFAIL: [chars] ACL merge error [dec] ([chars]) on [chars]
label [dec].
Explanation
The ACL manager could not complete the merge of the configured features into a form
suitable for loading into the hardware. Packets potentially affected by this feature will be sent to the
CPU for processing. The most likely cause is specifying an ACL that is too large or too complex for
the system. The first [chars] is the ACL-type error (ip or mac), the first [dec] is the error code, the
second [chars] is the message string for the preceding error code, the second [dec] is the label
number, and the third [chars] is either input or output.
Recommended Action Specify a smaller and less complicated configuration.
Error Message ACLMGR-3-NOLABEL: Cannot allocate [chars] label for interface [chars].
Explanation
the ACL manager could not allocate a label for the features on this interface. This
means that the hardware cannot be programmed to implement the features, and packets for this
interface will be filtered in the software. There is a limit of 256 labels per direction. The first [chars]
is the direction (input or output), and the second [chars] is the interface name.
Recommended Action Use a simpler configuration. Use the same ACLs on multiple interfaces, if
possible.
Error Message ACLMGR-3-OUTTTABLE: Not in truth table: RACL [dec] VLMAP [dec].
Explanation
An unrecoverable software error occurred while trying to merge the configured output
features. [dec] are internal action codes.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message ACLMGR-3-QOSTTABLE: Not in truth table: ACL [dec] in map, action [dec].
Explanation
A software error occurred while trying to merge a quality of service (QoS) policy map.
The first [dec] is the ACL number, and the second [dec] is the action corresponding to the specified
ACL number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
To Next Page
Loading...
Need help?
General