2-27
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
MAC_MOVE Messages
Error Message MAC_LIMIT-4-ENFORCE: Enforcing limit on Vlan [dec] with Configured
limit = [dec].
Explanation
The number of MAC address entries for the VLAN exceeds the maximum number
allowed. The configured action is to limit the number of entries to the maximum allowed. The first
[dec] is the VLAN ID, and the second [dec] is the maximum number of MAC address entries.
Recommended Action Contact your system administrator to configure this action.
Error Message MAC_LIMIT-4-EXCEED: Vlan [dec] with Configured limit = [dec] has
currently [dec] Entries.
Explanation
The number of MAC address entries for a VLAN exceeds the maximum number
allowed. The first [dec] is the VLAN ID, the second [dec] is the maximum number of MAC address
entries, and the third [dec] is the number of entries in the MAC address table.
Recommended Action Contact your system administrator to configure this action.
MAC_MOVE Messages
Error Message MAC_MOVE-4-NOTIF: Host [enet] in vlan [dec] is flapping between port
[chars] and port [chars].
Explanation
The host is moving between the specified ports. [enet] is the Ethernet address of the
host, [dec] is the VLAN ID, the first [chars] is the first port, and the second [chars] is the second port.
Recommended Action Check your network for loops.
PAGP_DUAL_ACTIVE Messages
Error Message PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation
The switch cannot create the specified managed object. [chars] is the object name.
Recommended Action No action is required.
Error Message PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars] informing
virtual switches of dual-active: new active id [enet], old id [enet]
Explanation
PAgP received a new active ID on the specified interface, which means that all virtual
switches are in a dual-active scenario. The interface is informing virtual switches of this, which
causes one switch to go into recovery mode. [chars] is the interface, the first [enet] is the new active
ID, and the second [enet] is the ID that it replaces.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General