Cisco 3845 - Security Bundle Router User Manual

2-8
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
BADTRANSCEIVER Messages
BADTRANSCEIVER Messages
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
Explanation
A defective module is installed in the specified interface. [chars] is the interface.
Recommended Action Remove the transceiver. If it was purchased from Cisco, contact your Cisco
representative to have the transceiver replaced.
BSPATCH Messages
Error Message BSPATCH-1-RELOAD: System will reboot to activate newly patched Boot
Loader.
Explanation
The switch automatically reboots after the boot loader is patched.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC,
or provide your Cisco technical support representative with your information. For more information
about these online tools and about contacting Cisco, see the “Error Message Traceback Reports”
section on page 1-5.
Error Message BSPATCH-1-PATCHED: Boot Loader patch ([chars]) installed.
Explanation
A boot loader patch installed successfully. [chars] is the SDRAM refresh timer register
setting.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC,
or provide your Cisco technical support representative with your information. For more information
about these online tools and about contacting Cisco, see the “Error Message Traceback Reports”
section on page 1-5.
Error Message BSPATCH-3-FAILED: Failed to install Boot Loader patch ([chars]).
Explanation
The switch did not apply a boot loader patch. [chars] is the SDRAM refresh timer
register setting.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English