2-45
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
PORT_SECURITY Messages
Error Message PM-4-PORT_BOUNCED: Port [chars] was bounced by [chars].
Explanation
During a change-over when the port was in the link-down state, the port manager
restarted the port. A port can be restarted only when the port data structures are not consistent in the
active and standby supervisors. Active ports in the link-down state return to the link-up state when
the port is restarted. The first [chars] is the port number, and the second [chars] is the re-activation
event.
Recommended Action No action is required.
Error Message PM-4-TOO_MANY_APP: application ’[chars]’ exceeded registration limit.
Explanation
The port manager detected an invalid request. [chars] is the application.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message PM-4-UNKNOWN_HOST_ACCESS: Invalid Host access value ([dec]) is
received.
Explanation
The host access table is being accessed with an invalid host access value. [dec] is the
value that is received.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
PORT_SECURITY Messages
Error Message PORT_SECURITY-2-PSECURE_VIOLATION: Security violation occurred caused
by MAC [enet] on port [chars].
Explanation
An unauthorized device attempted to connect on a secure port. [enet] is the MAC
address of the unauthorized device, and [chars] is the secure port.
Recommended Action Identify the device that attempted to connect on the secure port. Notify your
network system administrator of this condition.