2-9
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
CISL Messages
CISL Messages
Error Message CISL-1-DEVICE_CERT_NOT_PRESENT: Device Certificate used for licensing
is not present
Explanation
An error occurred while retrieving the device certificate used for licensing.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
EC Messages
Error Message EC-4-NOMEM: Not enough memory available for [chars].
Explanation
The Link Aggregation Control Protocol (LACP) or the Port Aggregation Protocol
(PAgP) EtherChannel could not obtain the memory it needed to initialize the required data
structures. [chars] is the data structure name.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message EC-5-BUNDLE: Interface [chars] joined port-channel [chars].
Explanation
The listed interface joined the specified EtherChannel. The first [chars] is the physical
interface, and the second [chars] is the EtherChannel interface.
Recommended Action No action is required.
Error Message EC-5-CANNOT_ALLOCATE_AGGREGATOR: Aggregator limit reached, cannot
allocate aggregator for group [dec].
Explanation
A new aggregator cannot be allocated in the group. [dec] is the affected group.
Recommended Action Change the port attributes of the ports in the group so that they match and join
the same aggregator.
To Next Page
Loading...
Need help?
General