Cisco 3845 - Security Bundle Router User Manual

2-35
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
PLATFORM_PM Messages
Error Message PLATFORM_PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware
upon retry.
Explanation
The PBR manager was able to fit the complete configuration into the hardware. One or
more route-maps previously did not load because of lack of resources. [chars] is the route-map.
Recommended Action No action is required.
PLATFORM_PM Messages
Error Message PLATFORM_PM-3-IFCOUNTERROR: Unit number [dec] of interface [chars] is
more than max allowed value of [dec].
Explanation
There are too many interfaces configured for the interface type. [dec] is the interface
count, [chars] is the interface, and [dec] is the maximum number of interfaces.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message PLATFORM_PM-3-INTVLANINUSE: internal vlan-id [dec] allocated for
interface [chars] is still in use.
Explanation
An internal VLAN ID allocated for an interface is still in use. [dec] is the VLAN ID,
and [chars] is the interface.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message PLATFORM_PM-3-NOINTVLAN: internal vlan of interface [chars] is not
active for vlan-id [dec].
Explanation
The internal vlan_data is not active for the given VLAN ID. [chars] is the interface, and
[dec] is the VLAN ID.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English