2-75
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
VQPCLIENT Messages
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
VQPCLIENT Messages
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Explanation
The system has shut down the specified interface because too many hosts have requested
access to that interface. [chars] is the interface name.
Recommended Action To enable the interface, remove the excess hosts, and enter the no shutdown
interface configuration command on the interface.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN ([chars]) in response.
Explanation
The VMPS has specified an unknown VLAN name. [chars] is the invalid VLAN name.
Recommended Action Ensure that the VLAN exists on the switch. Verify the VMPS configuration by
using the show vmps privileged EXEC command.