Cisco 3845 - Security Bundle Router User Manual

2-55
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
REP Messages
Error Message QOSMGR-4-VLAN_LABEL_EXCEED_MAX: Exceeded a maximum of active vlan
classifications.
Explanation
The number of VLAN classifications required for all attached per-port, per-VLAN QoS
policies exceeds the maximum number of VLAN classifications that are supported by this hardware.
Recommended Action Reconfigure the attached per-port, per-vlan QoS policies to reduce the number
of VLANs used for classification.
REP Messages
Error Message REP-3-INVALIDPKT: received invalid pkt: [chars]
Explanation
The switch has received an invalid Resilient Ethernet Protocol (REP) packet. [chars] is
information about the invalid packet.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message REP-3-NOPPPROC: [traceback] Failed to create REP LSL Fast Hello Process
Explanation
The switch cannot exchange hello packets with its REP neighbors because the Link
Status Layer (LSL) age timer is set to more than 3 seconds.
Recommended Action Reload the switch.
Error Message REP-4-LINKSTATUS: [chars] (segment [dec]) is [chars]
Explanation
The REP-interface link status has changed. The first [chars] is the interface name. The
[dec] is the REP segment number of the interface, and the second [chars] is the new link status.
Recommended Action No action is required.
Error Message REP-5-PREEMPTIONFAIL: can not perform preemption on segment [dec] due
to [char]
Explanation
The REP preempt operation failed. This could be due to an invalid port ID or a
neighbor_offset number specified with the rep block port interface configuration command. This
could also be caused by entering the rep block port preferred interface configuration command if
there is no REP port configured with the preferred keyword. [dec] is the segment number, and
[char] is the reason for the failure.
Recommended Action Correct the configuration. Run REP manual preemption on the primary edge
port by using the rep preempt segment command.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English