2-30
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-23408-01
Chapter 2 Messages and Recovery Procedures
PIMSN Messages
PIMSN Messages
Error Message PIMSN-6-IGMPSN_GLOBAL: PIM Snooping global runtime mode [chars] due to
IGMP Snooping [chars].
Explanation
When IGMP snooping is disabled, Protocol Independent Multicast (PIM) snooping is
disabled. When IGMP snooping is re-enabled, PIM snooping is re-enabled. The first [chars] is the
PIM snooping mode, and the second [chars] is the IGMP snooping mode.
Recommended Action No action is required.
Error Message PIMSN-6-IGMPSN_VLAN: PIM Snooping runtime mode on vlan [dec] [chars]
due to IGMP Snooping [chars].
Explanation
When IGMP snooping is disabled, PIM snooping is disabled. When IGMP snooping is
re-enabled, PIM snooping is re-enabled. [dec] is the VLAN ID, the first [chars] is the PIM snooping
mode, and the second [chars] is the IGMP snooping mode.
Recommended Action No action is required.
PLATFORM Messages
Error Message PLATFORM-1-CRASHED: [chars].
Explanation
The system is trying to display the failure message from the previous failure. [chars] is
the description of the error message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message PLATFORM-3-NO_HARDWARE_RESOURCES: Not enough hardware resources.
Shutting down [chars].
Explanation
There are too many VLANs and routed ports. [chars] is the short interface name, such
as Gi0/1, or the VLAN name, such as VLAN0002.
Recommended Action Reduce the total number of VLANs and routed ports to less than 1023. To
preserve configurations and connections across reboots, save the configuration.
To Next Page
Loading...
Need help?
General