• USB to USB Cable: for Cisco IP Phones with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
Your Cisco IP Phone administrator must enable hookswitch calling for the Y-Cable
to work.
Note
• Mini USB Cable: for PC or Mac.
Figure 5: Multibase LEDs
The following table describes the multibase.
Table 8: Multibase LEDs
DescriptionNameNumber
Indicates the headset battery charge and base status:
• Headset battery strength—LEDs blink and change to
solid as the battery charges.
• Headset update in progress—LEDs blink in sequence,
left to right.
• Headset and base not paired—All LEDs blink
• Power save mode—Middle LED shows solid.
The base enters power save mode when there is no call source
connectivity after 10 minutes.
Battery Status LED1
Cisco Headset 500 Series User Guide
8
Your Headset
Cisco Headset 560 Series Multibase
To Next Page
Loading...
