Cisco 521 - End a Call and Answer an Incoming Call

Step 3 Press Call.
End a Call and Answer an Incoming Call
Procedure
Step 1 Hold Call until you hear a tone.
Step 2 Press Call once.
End a Call and Resume a Held Call
Procedure
Step 1 Hold Call until you hear a tone.
Step 2 Select the call that you want to resume.
Step 3 Press Call once.
Wireless Headsets
Cisco Headset 561 and 562 with Standard Base and Cisco Headset 561 and 562 with Multibase use similar
call controls to the wired headset models with a few important differences. The call control buttons are located
on the headset ear cup and call status feedback is provided on the Standard Base and Multibase. See the
following section for specific call control functions.
Related Topics
Cisco Headset 560 Series, on page 4
Turn Your Headset On and Off
Procedure
Step 1 Hold Call on your headset for 4 seconds. You will hear a tone indicating headset status.
Step 2 Hold Call for another 4 seconds to turn the headset back on.
• You can also place the headset on its base. The headset automatically turns on and syncs to the base.
Cisco Headset 500 Series User Guide
17
Calls
End a Call and Answer an Incoming Call