Figure 4: Standard Base LEDs
The following table describes the standard base.
Table 7: Standard Base LEDs
DescriptionNameNumber
Indicates the headset battery charge and base status:
• Headset battery strength—LEDs blink and change to
solid as the battery charges.
• Headset update in progress—LEDs blink in sequence,
left to right.
• Headset and base not paired—All LEDs blink
• Power save mode—Middle LED shows solid.
The base enters power save mode when there is no call source
connectivity after 10 minutes.
Battery Status LED1
Alerts you to the call state:
• Incoming call—Blinking green
• Active call—Steady green
• Muted call—Steady red
Call Status LED2
Cisco Headset 560 Series Multibase
The multibase can connect up to three call sources through Bluetooth, the USB connector, or the Y-cable.
You can switch between call sources using the button interface on the multibase. You can answer and end
calls by selecting the call control buttons on your headset, or by lifting and returning your headset to the base.
The multibase comes with the following connector cables:
Cisco Headset 500 Series User Guide
7
Your Headset
Cisco Headset 560 Series Multibase
To Next Page
Loading...
