5
Cisco 5520 and 8540 Wireless Controller Troubleshooting Guide
Logging in to CIMC
CIMC is a separate management module that is built into the motherboard. CIMC has its own
ARM-based processor which runs the CIMC software. It is shipped with a running version of the
firmware. Users can update CIMC firmware through the Firmware Update Management page. You need
not worry about installing the initial CIMC firmware.
Logging in to CIMC
Before starting
Check if Adobe Flash Player 10 or higher is installed on your local machine.
Step 1 Type or select the web link for CIMC in your web browser.
Step 2 A security dialog box is displayed, do the following:
a. Optional: Check the check box to accept all content from Cisco.
b. Click Yes to accept the certificate and continue.
Step 3 Enter your Username and password in the log in window.
Step 4 Click Log In.
Setting up CIMC
Setting up CIMC for 5520 and 8540 Wireless Controller
To setup the CIMC interface follow the given steps:
Step 1 Connect the CIMC cable to the 10/100/1000 port in base T.
Step 2 Use the command imm dhcp enable on WLC CLI to enable DHCP to set the IP.
Step 3 If DHCP is not available, use the command imm address <ip address> <net mask> <gateway ip>.
View the IP and details, using the command imm summary.
imm ?
address IMM Static IP Configuration
dhcp Enable | Disable | Fallback DHCP
restart Saves settings and Restarts IMM Module
summary Displays IMM Parameters
username Configures Login Username for IMM
To Next Page
Loading...
Need help?
General
