8
Cisco 5520 and 8540 Wireless Controller Troubleshooting Guide
Configure/View CIMC IP from console during bootup
Retry Count: 7
Retry Interval (ms): 500
Volatile Bit Rate (kbps): 115.2
Non-Volatile Bit Rate (kbps): 115.2
Payload Channel: 14 (0x0e)
Payload Port: 623
>show imm chassis memory
Size: 8192 MB
Locator: DIMM_A1
Size: No Module Installed
Locator: DIMM_A2
Size: No Module Installed
Locator: DIMM_A3
Size: 8192 MB
Locator: DIMM_B1
Size: No Module Installed
Locator: DIMM_B2
Size: No Module Installed
Locator: DIMM_B3
Size: 8192 MB
Locator: DIMM_C1
Size: No Module Installed
Locator: DIMM_C2
Size: No Module Installed
Locator: DIMM_C3
Size: 8192 MB
Locator: DIMM_D1
Size: No Module Installed
>debug fastpath dump temperature
Debug command to see the Dataplane card temperature
FP0.21:Address of Temp sensor SA56004 is 4c
FP0.21:
Configured Temperature values:
FP0.21:Crit Remote/local=105,90 Remote High/Low = 85,0 Local High/Low = 85,0
FP0.21:Status Reg= 0 Config =1 ,hysteresis=10
FP0.21:Octeon temp: 50.250 C, SA56004 temp: 25.750 C, Max/Min Temp = 55 / 0 C
FP0.21:
GPIO Stats:
FP0.21:Fan Status: Not Present
FP0.21:Temperature alert: Happened
Gives some advanced debugs for temperature related issue
Configure/View CIMC IP from console during bootup
Press F8 in the BIOS screen at the time of Bootup to view CIMC IP address configuration and to reset
password.
Step 1 Choose either DHCP or Static config.
Step 2 Enter the VLAN tag if needed.
Step 3 Enter the CIMC password.
To Next Page
Loading...
Need help?
General
