Cisco 7600 Series Hardware

32
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
XENPAKs
X2-DWDMs 12.2(33)SRE
Note
•
To configure WS-X6708-10GE port oversubscription, refer to the hw-module oversubscription command in the
command reference at this URL:
http://www.cisco.com/en/US/products/ps6922/prod_command_reference_list.html
• Installation of a WS-X6708-10GE switching module in a chassis other than the following prevents operation at levels
that are fully NEBS-compliant:
– WS-C6503-E
– WS-C6504-E
– WS-C6506-E
– WS-C6509-E
– WS-C6509-NEB-A with dual fan tray
– CISCO7604
– CISCO7609 with dual fan tray
• WS-X6708-10G-3C and WS-X6708-10G-3CXL are the orderable product IDs.
• The front panel is labeled WS-X6708-10GE.
• Cisco IOS software commands display WS-X6708-10GE with either WS-F6700-DFC3C or WS-F6700-DFC3CXL.
• WS-X6708-10GE ports do not supportVACL capture. (CSCsb59015)
• WS-X6708-10GE is not supported in the WS-C6503 and CISCO 7603 chassis.
• In a 13-slot chassis, WS-X6708-10GE is supported only in slots 9 through 13 and does not power up in other slots.
• On WS-X6708-10GE ports, STP BPDUs are not exempt from Traffic Storm Control suppression. Do not configure Traffic
Storm Control on STP-protected WS-X6708-10GE ports that interconnect network devices.
Product ID
(append “=” for spares) Product Description
Minimum
Software Version
DWDM-XENPAK
10GBASE dense wavelength division multiplexing (DWDM) 100-GHz ITU grid 12.2(33)SRA
WDM-XENPAK-REC
10GBASE receive-only wavelength division multiplexing (WDM) 12.2(33)SRA
XENPAK-10GB-CX4
10GBASE for CX4 cable 12.2(33)SRA
XENPAK-10GB-SR
10GBASE-SR Serial 850-nm short-reach multimode fiber (MMF) 12.2(33)SRA
XENPAK-10GB-LX4
10GBASE-LX4 Serial 1310-nm multimode fiber (MMF) 12.2(33)SRA
XENPAK-10GB-ER
10GBASE-ER Serial 1550-nm extended-reach, single-mode fiber (SMF),
dispersion-shifted fiber (DSF)
12.2(33)SRA
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13