DescriptionParameter
Select the device identifier to include in syslog
messages that are uploaded to the syslog server. The
device identifier appears after the timestamp in each
message.
• None: No device identifier.
• $MA: The MAC address of the phone, expressed
as continuous lower case letters and digits.
Example: c4b9cd811e29
• $MAU: The MAC address of the phone,
expressed as continuous upper case letters and
digits. Example: C4B9CD811E29
• $MAC: The MAC address of the phone in the
standard colon-separated format. Example:
c4:b9:cd:81:1e:29
• $SN: The product serial number of the phone.
Default: None
Example XML configuration:
<Syslog_Identifier
ua="na">$MAC</Syslog_Identifier>
Syslog Identifier
The debug level from 0 to 2. The higher the level, the
more debug information is generated. Zero (0) means
that no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Default: 0
Debug Level
IP address or name of the primary NTP server used
to synchronize its time.
Default: Blank
Primary NTP Server
IP address or name of the secondary NTP server used
to synchronize its time.
Default: Blank
Secondary NTP Server
Choose Yes to enable SSLv3. Choose No to disable.
Default: No
Enable SSLv3
VLAN Settings
DescriptionParameter
Choose Yes to enable VLAN. Choose No to disable.Enable VLAN
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
230
Cisco IP Phone Troubleshooting
VLAN Settings
To Next Page
Loading...
Need help?
General
