Cisco 7912G At-A-Glance

5
Adjusting the Handset Rest
When you connect your phone, you might want to adjust the
handset rest to ensure that the receiver will not slip out of the
cradle. This is especially important if the phone will hang from
a wall. Refer to the following table for instructions.
Figure 2 Using the Handset Rest
1
Set the handset aside and use your thumb and finger to
grasp and pull the square plastic tab from the handset rest.
2
Rotate the tab 180 degrees.
3
Slide the tab back into the handset rest with the extension
protruding from the top of the tab.
Replace the handset in the rest. The tab hooks into a slot
in the handset to ensure that the handset will not slip out
of the rest.
1 2 3
77354

Cisco 7912G Specifications

General

Brand	Cisco
Model	7912G
Category	IP Phone
Language	English