Cisco 7937G - Unified IP Conference Station VoIP Phone - Network Configuration Menu

4-5
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 4 Configuring Settings on the Conference Station
Network Configuration Menu
Related Topics
• Displaying a Configuration Menu, page 4-2
• Unlocking and Locking Options, page 4-3
• Editing Values, page 4-3
• Network Configuration Menu, page 4-5
• Device Configuration Menu, page 4-8
• Security Configuration Menu, page 4-12
Network Configuration Menu
The Network Configuration menu provides options for viewing and configuring a variety of network
settings.
Table 4-3 describes these options and, where applicable, explains how to change them.
For information about how to access the Network Configuration menu, see the “Displaying a
Configuration Menu” section on page 4-2.
Before you can change an option on this menu, you must unlock options. See the “Unlocking and
Locking Options” section on page 4-3 for more information.
For information about the keys you can use to edit options, see the “Editing Values” section on page 4-3.
Ta b l e 4-2 Security Settings Configurable from the Conference Station
Category Description Security Configuration Menu Option
Security settings Allow you to enable 802.1X
authentication
802.1X Authentication
Ta b l e 4-3 Network Configuration Menu Options
Option Description To Change
DHCP Enabled Indicates whether DHCP is being
used by the conference station.
1. Unlock network configuration options. For more information,
see the
“Unlocking and Locking Options” section on page 4-3.
2. Choose Applications > Settings > Network Configuration >
DHCP Enabled.
3. Select Enabled to enable DHCP or Disabled to disable DHCP.
4. Press Select, and then press Save.
IP Address Internet Protocol (IP) address of
the conference station.
If you assign an IP address with
this option, you must also assign a
subnet mask and default router. See
the Subnet Mask and Default
Router options in this table.
1. Unlock network configuration options. For more information,
see the
“Unlocking and Locking Options” section on page 4-3.
2. Set the DHCP Enabled option to No. For more information, see
the DHCP Enabled option in this table.
3. Choose Applications > Settings > Network Configuration >
IP Address.
4. Enter a new IP Address.
5. Press Validate, and then press Save.