Cisco 7937G - Unified IP Conference Station VoIP Phone - Status Menu; Network Statistics Screen

7-2
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 7 Viewing Model Information, Status, and Statistics on the Conference Station
Status Menu
• BootROM Version—Identifier of the factory-installed load running on the conference station.
• App Load ID—Identifies the firmware running on the conference station.
To display the Model Information screen, choose Applications > Settings > Model Information. To
exit the Model Information screen, press Exit.
Status Menu
The Status menu includes these options, which provide information about the conference station and its
operation:
• Network Statistics—Displays the Network Statistics screen, which shows Ethernet traffic statistics.
For more information, see the
“Network Statistics Screen” section on page 7-2.
• Call Statistics—Displays information about the last call on the conference station. For more
information, see the
“Call Statistics Screen” section on page 7-4.
• Device Information—Displays device settings and related information for the conference station.
For more information, see the
“Device Information Screen” section on page 7-5.
Note The Status menu also contains a Ping menu that allows you to test network connectivity to another
conference station. For more information, see the “Using Ping” section on page 9-2
To display the Status menu, choose Applications > Settings > Status. To exit the Status menu, press
Exit.
Network Statistics Screen
The Network Statistics screen displays information about the conference station and network
performance.
Table 7-1 describes the information that appears in this screen.
To display the Network Statistics screen, choose Applications > Settings > Status >
Network
Statistics.
To reset the Rx Frames, Tx Frames, and Rx Broadcasts statistics to 0, press Clear. To exit the
Network
Statistics screen, press Exit.
Ta b l e 7-1 Network Statistics Items
Item Description
Rx Frames Number of packets received by the conference station.
Tx Frames Number of packets transmitted by the conference station.
Rx error Total number of FCS error packets or Align error packets received.
Rx PacketNoDes Total number of shed packets caused by no DMA descriptor.
Rx Overruns Total number of received packets dropped because of buffer overruns.
Rx alignErr Total number of packets received between 64 and 1522 bytes in length that
have bad FCS errors.
Rx length error Number of packets discorded due to improper length.