5-9
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17679-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Cisco Unified IP Phone
Immediate Divert Allows a user to transfer a ringing, connected, or
held call directly to a voice-messaging system.
When a call is diverted, the line becomes available
to make or receive new calls.
For more information, refer to the Cisco
Unified
Communications Manager Features
and Services Guide, “Immediate Diver”
chapter.
Immediate
Divert—Enhanced
Allows users to transfer incoming calls directly to
their voice messaging system or to the voice
messaging system of the original called party.
For more information, refer to:
• Cisco Unified Communications Manager
System Guide, “Cisco Unified IP Phones”
chapter.
• Cisco Unified Communications Features
and Services Guide, “Call Park and
Directed Call Park” chapter.
Intercom Allows users to place and receive intercom calls
using programmable phone buttons. You can
configure intercom line buttons to:
• Directly dial a specific intercom extension.
• Initiate an intercom call and then prompt the
user to enter a valid intercom number.
Note If your user logs into the same phone on a
daily basis using their Cisco Extension
Mobility profile, assign the phone button
template that contains intercom
information to their profile, and assign the
phone as the default intercom device for
the intercom line.
Cisco Unified Communications Manager
Feature and Services Guide, “Intercom
chapter”
Join/Select Creates a conference by joining together existing
calls that are on a single phone line.
For more information, refer to Cisco
Unified
IP Phone Guide, “Basic Call
Handling” chapter, “Making Conference
Calls” section.
Join Across
Lines/Select
(SCCP only)
Allows users to apply the Join feature to calls that
are on multiple phone lines.
For more information:
• See the “Configuring Softkey Templates”
section on page 5-18
• Refer to Cisco Unified Communications
Manager System Guide, “Cisco Unified IP
Phones” chapter.
Line select If this feature is disabled (default), then the
ringing line is selected. When enabled, the primary
line is picked up even if a call is ringing on another
line. The User must manually select the other line.
Note This feature can also be enabled or
disabled for Extension Mobility.
For more information, refer to the option
“Always use prime line” in the following
chapters of Cisco Unified Communications
Manager Administration Guide:
• “Device Profile Configuration Settings”
• “Common Phone Profile Configuration
Settings”
• “Phone Configuration Settings”
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference
To Next Page
Loading...
Need help?
General
