3-7
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17679-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
Ta b l e 3-1 Installing the Cisco Unified IP Phone 7962G and 7942G
Procedure Notes Reference
Step 1
Connect the handset to the Handset
port.
— —
Step 2
Connect a headset to the Headset
port.
Optional. You can add a
headset later if you do
not connect one now.
See the “Headset” section on page 3-4 for
supported headsets.
Step 3
Connect a wireless headset. Optional. You can add a
wireless headset later if
you do not want to
connect one now.
Refer to the wireless headset documentation
for information.
Step 4
Connect the power supply to the
Cisco DC Adapter port.
Optional. See the “Adding Phones to the Cisco Unified
Communications Manager Database” section
on page 2-8 for guidelines.
Step 5
Connect a straight-through
Ethernet cable from the switch to
the network port labeled 10/100
SW on the Cisco
Unified
IP
Phone 7962G and 7942G.
Each Cisco Unified IP Phone ships
with one Ethernet cable in the box.
You can use either
Category 3/5/5e cabling
for 10-Mbps
connections, but you
must use Category 5/5e
for 100 Mbps
connections.
See the “Network and Access Ports” section
on page 3-3 for guidelines.
Step 6
Connect a straight-through
Ethernet cable from another
network device, such as a desktop
computer, to the access port labeled
10/100 PC port on the
Cisco
Unified IP Phone 7962G and
7942G.
Optional. You can
connect another network
device later if you do not
connect one now.
You can use either
Category 3/5/5e cabling
for 10-Mbps
connections, but you
must use Category 5/5e
for 100 Mbps
connections.
See the “Network and Access Ports” section
on page 3-3 for guidelines.
To Next Page
Loading...
