Cisco 7945G - Page 113

5-9
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Phone
Intercom Allows users to place and receive intercom calls using
programmable phone buttons. You can configure
intercom line buttons to:
• Directly dial a specific intercom extension.
• Initiate an intercom call and then prompt the user to
enter a valid intercom number.
Note If your user logs into the same phone on a daily
basis using their Cisco Extension Mobility
profile, assign the phone button template that
contains intercom information to their profile,
and assign the phone as the default intercom
device for the intercom line.
• Cisco Unified CallManager Feature and
Services Guide, “Intercom chapter”
• Cisco Unified CallManager Feature and
Services Guide, “Cisco Extension
Mobility” chapter
Join/Select Creates a conference by joining together existing calls
that are on a single phone line.
For more information, refer to Cisco
Unified
IP Phone Guide, “Basic Call
Handling” chapter, “Making Conference
Calls” section.
Join Across Lines
(SCCP phones
only)
Allows users to apply the Join feature to calls that are on
multiple phone lines.
For more information:
• See the “Configuring Softkey
Templates” section on page 5-18.
Refer to Cisco Unified Communications
Manager System Guide, “Cisco Unified IP
Phones” chapter.
Line select If this feature is disabled (default), then the ringing line
is selected. When enabled, the primary line is picked up
even if a call is ringing on another line. The user must
manually select the other line.
Note This feature can also be enabled or disabled for
Extension Mobility.
For more information, refer to the option
“Always use prime line” in the following
chapters of Cisco Unified Communications
Manager Administration Guide:
• “Device Profile Configuration Settings”
• “Common Phone Profile Configuration
Settings”
• “Phone Configuration Settings”
Line select for
voice messages
When disabled (default), pressing the Messages button
selects the line that has a voice message. If more than
one line has voice mail, then the first available line is
selected. When enabled, the primary line is always used
to retrieve voice messages.
Note This feature can also be enabled or disabled for
Extension Mobility.
For more information, refer to the option
“Always use prime line for voice message” in
the following chapters of Cisco Unified
Communications Manager Administration
Guide:
• “Device Profile Configuration Settings”
• “Common Phone Profile Configuration
Settings”
• “Phone Configuration Settings”
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference