Cisco 7945G

4-13
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
SIP Configuration Menu (SIP Phones Only)
The SIP Configuration menu is available on SIP phones. This menu contains these sub-menus:
• SIP General Configuration Menu, page 4-13
• Line Settings Menu (SIP Phones Only), page 4-14
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on a
SIP phone.
Table 4-6 describes the options in this menu.
(Authentication icon)
Appears as a shield and indicates that the connection
to the Cisco Unified Communications Manager is
authenticated. For more information about
authentication, refer to the Cisco Unified
Communications Manager Security Guide.
(Encryption icon)
Appears as a padlock and indicates that the
connection to the Cisco Unified Communications
Manager is authenticated and encrypted. For more
information about authentication and encryption,
refer to the Cisco Unified Communications Manager
Security Guide.
Table 4-5 Cisco Unified Communications Manager Server Designations (continued)
Designation Description
Ta b l e 4-6 SIP General Configuration Menu Options
Option Description To Change
Preferred CODEC Displays the CODEC to use when a call is initiated. This value
will always be set to none.
Display only—cannot configure.
Out of Band DTMF Displays the configuration of the out-of-band signaling (for
tone detection on the IP side of a gateway). The Cisco Unified
IP phone (SIP) supports out-of-band signaling by using the
AVT tone method. This value will always be set to avt.
Display only—cannot configure.
Register with Proxy Displays if the phone must register with a proxy server during
initialization. This value will always be set to Yes.
Display only—cannot configure.
Register Expires Displays the amount of time, in seconds, after which a
registration request expires.
From Cisco Unified Communications
Manager Administration, choose
Device
>
Device Settings > SIP Profile.
Phone Label Displays the text that is displayed on the top right status line
of the LCD on the phone. This text is for end-user display only
and has no effect on caller identification or messaging. This
value will always be set to null.
Display only—cannot configure.