Cisco 7965G User Manual

22 OL-12643-01
Tip
If parties on a call hear a beep tone, the call might be monitored or recorded. Ask your system
administrator for more information.
Ending a Call
To end a call, simply hang up. Here are some more details.
Answer a priority call
(SCCP phones only)
Hang up the current call and press
Answer.
Prioritizing Critical Calls,
page 41
Answer a call on your
cellular phone or other
remote destination
Set up Mobile Connect and answer your
phone.
When you enable Mobile Connect:
• Your desktop and remote
destinations receive calls
simultaneously.
• When you answer the call on your
desktop phone, the remote
destinations stop ringing, are
disconnected, and display a missed
call message.
• When you answer the call on one
remote destination, the other remote
destinations stop ringing, are
disconnected, and a missed call
message is shown on the other
remote destinations.
Using Cisco Extension
Mobility, page 43
If you want to... Then...
Hang up while using the handset Return the handset to its cradle. Or press EndCall.
Hang up while using a headset Press . Or, to keep headset mode active, press EndCall.
Hang up while using the speakerphone Press or EndCall.
Hang up one call, but preserve another
call on the same line
Press EndCall. If necessary, remove the call from hold first.
If you want to... Then... For more information, see...

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC