Cisco Unified IP Phone 7965G and 7945G for Cisco Unified Communications Manager 6.0 (SCCP and SIP) 33
• Talk to the caller by pressing the active intercom button, and use either the handset, headset or
speaker. The intercom call becomes a two-way connection so that you can converse with the caller.
When using the intercom feature, be aware of the following:
• From an intercom line, you can only dial other intercom lines.
• You can use only one intercom line at a time.
• If you answer an intercom call while another intercom line is active, the first intercom call is dropped.
• When your active call is being monitored or recorded, you cannot receive or place intercom calls.
If you want to... Then...
Place an intercom call to a
preconfigured intercom target
Press (intercom target line) and, after you hear the
intercom-alert tone, begin speaking.
Place an intercom call to any
intercom number
Press (an intercom line). Enter the intercom target number or
press a speed-dial number for your target. After you hear the
intercom-alert tone, begin speaking.
Receive an intercom call When you hear the intercom-alert tone, handle the call in one of these
ways:
• Listen to the message in one-way audio.
• Speak to the caller by pressing (the active intercom line).
• Press EndCall.
• The call then becomes a basic two-way call except that no
special features are available. You can stay in speakerphone
mode or go to handset or headset mode as you would with a
basic call.
To Next Page
Loading...
Need help?
General
