Cisco 8700 Series - Page 5

Required Tools and Equipment 82
Installing the Transceiver Module 83
Attach the Optical Network Cable 86
Removing the Transceiver Module 88
Connect Interface Ports 90
Disconnect Optical Ports from the Network 90
Maintain Transceivers and Optical Cables 90
Create the Initial Router Configuration 90
Verify Chassis Installation 92
Replace Chassis Components 107
CHAPTER 6
Replace Modular Port Adapters 107
Remove a Modular Port Adapter 107
Install a Modular Port Adapter 108
Replace Blank Cards 110
Remove a Blank Card 110
Install a Blank Card 110
Replace Fan Modules 111
Replace Power Supply 113
LEDs 115
CHAPTER 7
LEDs for Cisco 8711-32FH-M Router 115
Chassis LEDs 115
Port Status LEDs 116
LEDs for Cisco 8712 Router 117
Chassis LED 117
MPA LEDs 118
Fan LED 120
Power Supply LEDs 122
Hardware Installation Guide for Cisco 8700 Series Routers
v
Contents