Cisco 8700 Series - Page 77

Table 13: Cisco 8711-32FH-M Fixed Port Router Front View Port Description
Mini coax connector for 1 PPS,
input, and output.
632 QSFP56-DD 400GbE ports or 16 QSFP-DD
800G ports. These ports support the following
breakout operation:
• 2x400 GbE
• 8x100 GbE
• 4x100 GbE
• 2x100 GbE
• 4x10 GbE
• 4x25 GbE
• For the Port-Side Intake (PSI) configuration,
he QDD-400G-ZR-S, QDD-400G-ZRP-S,
and DP04QSDD-HE0 optical modules are
only supported on the even-numbered ports
(top row).
• For the Port-Side Exhaust (PSE)
configuration, he QDD-400G-ZR-S,
QDD-400G-ZRP-S, and DP04QSDD-HE0
optical modules are only supported on the
odd-numbered ports (bottom row).
Note
You must have dust caps installed on the unused
ports.
1
Mini coax connector for 10MHz,
input, and output
7Console port2
10G Control Plane Expansion port8Time of the Day (ToD) port3
1G Management port9GNSS port
Note
Lifting the signal amplitude to the suitable range
for the receiver frontend. The amplification
required is 20dB gain + cable/connector loss +
Splitter signal loss. The recommended range of
LNA gain (minus all cable and connector losses)
at the connector of the receiver module is a
minimum of 20dB and a maximum of 45dB.
4
USB Port Type-A5
Hardware Installation Guide for Cisco 8700 Series Routers
71
Connect Router to the Network
Interfaces and Port Description