Step 10 Use a screwdriver to fasten the screws into the phone and into each key expansion module.
This step ensures that the phone and key expansion modules remain connected at all times. This diagram
shows the location of the screw holes.
Make sure that the screws are fully inserted into the phone and tightened.
Note
Step 11 (Optional) Install the footstands on the phone and on the key expansion modules, and adjust all footstands to
rest evenly on the work surface.
Step 12 Plug the Ethernet cable into the phone.
Auto Detection of Key Expansion Modules
You can configure a new phone to auto-detect the maximum number of key expansion modules that it supports.
For these phones, the Number of Units field shows the maximum number of key expansion modules that the
phone supports as the default value. When a user adds key expansion modules to these phones, the module
lights up and is enabled automatically. Default value of this field is 2 for Cisco IP Phone 8851 and 3 for Cisco
IP Phone 8861. Navigate to Admin Login > Advanced > Voice > Att Console to check the value of the
Number of Units field.
If your user has an older release phone and it is upgraded to the current release, you can change the cofiguration
of the phone so that when the user adds a key expansion module to the phone, it lights up and is enabled
automatically.
Cisco IP Phone Accessories
23
Cisco IP Phone Accessories
Auto Detection of Key Expansion Modules
To Next Page
Loading...
Need help?
General
