Cisco 8851 Manual

• Cisco IP Phone 8800 Series Wall Mount Kit with Single KEM: The kit is installed on the Cisco IP Phone
8851, and 8861 with one attached Cisco IP Phone 8800 Key Expansion Module. The PID is
CP-8800-BEKEM-WMK=
Non-Lockable Wall Mount Components
This section describes how to install the Cisco IP Phone 8800 Series Wall Mount Kit.
The following figure shows the components of the Cisco IP Phone 8800 Series Wall Mount Kit.
Figure 6: Components
The package contains the following items:
• One phone bracket
• One wall bracket
• Four #8-18 x 1.25-inch Phillips-head screws with four anchors
• Two K30x8mm self-tapping screws
• One 6-inch Ethernet cable
The following figure shows the wall mount kit installed on the phone.
Cisco IP Phone Accessories
34
Cisco IP Phone Accessories
Non-Lockable Wall Mount Components

Cisco 8851 Specifications

General

Resolution	800 x 480 pixels
Network Interfaces	Dual Gigabit Ethernet ports
Headset Port	Yes
Audio	Wideband audio
Ethernet	10/100/1000 Mbps
USB	Yes, USB 2.0
Power	IEEE 802.3af/at Power over Ethernet (PoE)
Protocols	SIP
PoE	Yes
Codec Support	G.711, G.722, G.729, iLBC
Headset Connector	RJ9
Lines	Up to 5 lines
Dimensions	229 x 256 x 41 mm (excluding foot stand)
Weight	1.2 kg