The following table describes the multibase.
Table 24: Multibase LEDs
DescriptionNameNumber
Indicates the headset battery charge:
Also indicates when the headset firmware is being upgraded
and when the base is not paired with a headset.
Battery Status LED1
Alerts you to the call state:
• Active Source—Steady white
• Incoming call—Blinking green
• Active call—Steady green
• Call on an inactive source—Pulse green
Call Status LEDs2
Alerts you when your headset is muted.Mute Status LED3
Alerts you to the Bluetooth status:
• Paired with a call source—Steady white
• Pairing mode—Blinking white
• Searching for a call source—Pulse white
• Bluetooth is Off—LED is blank
Bluetooth Status LED4
You use the source control buttons on the base to control the active source. Each source button corresponds
with a specific connection on the multibase.
When you work with your multibase:
• You select which call source you want to use with the call source controls on the Multibase. The LED
next to each selected source lights up when the source is selected.
• Even if you are connected to a source, the LED may not be lit. The source LED only lights when the
source is selected or has an active call. For example, you may be properly connected to a Cisco IP Phone,
your PC, and your mobile phone through Bluetooth. However, the respective source LED is only lit when
it is selected, has an active call, or has an incoming call. Press the source button to check if a source is
properly connected. The source LED flashes three times if there is no connection.
• You can alternate between active call sources. Place an active call on hold before you change to a different
call source. Calls on one call source aren't automatically put on hold when you switch to a different call
source.
• The call source on the lower right of the source console corresponds with the USB port. It is designed
for use with Cisco IP Phones connected with the provided USB cable or the Y-Cable.
• The call source in the lower left corner of the source console connects to devices connected through
Bluetooth.
To Next Page
Loading...
