Cisco 8961 Release Notes

HeadlineIdentifier
Toast appear three times while insert two cameraCSCug23873
Busy is not returned by phone when push a service to a busy phoneCSCug24048
Rcvr/Sender audio Packets will be recount after pc port is disconnecteCSCug31002
Actional alert is malformed when much info is displayedCSCug31051
9951 Phone rejects incoming INVITE containing "Accept-language" in SRSTCSCug37105
DN not dialing out when select item from call log during active callCSCug42324
No dial UI if press speaker after specific URI dialing operationsCSCug50315
Resolved caveats
The following table lists severity 1, 2, and 3 defects that are resolved for the Cisco Unified IP Phones for
Firmware Release 9.3(2)SR1.
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were resolved at
the time this report was compiled. For an updated view of resolved defects, access Bug Toolkit as described
in Access Cisco Software Bug Toolkit, on page 7.
Table 3: Resolved Caveats for Firmware Release 9.3(2)SR1
HeadlineIdentifier
Doc: 89XX/99XX phones drop transfer/conference attempt during UI updateCSCtw72806
99xx phones - line status stuck on hold state - phantom holdCSCub40585
Empty session bubble on phone if barge between shared linesCSCuc23474
Improper call history of BLF pickupCSCuc38497
Session key ignored after call ended on 9951 and 9971 phonesCSCuc42087
Problematic reception report blocks in RTCP from 99xx IP PhoneCSCuc84336
Firmware 9-3-2-10 changed behavior on 99xx phones with BLF transferCSCud07738
De-Escalation of secure video to audio leads to call drop.CSCud08750
Cisco Unified IP Phone 8961, 9951, and 9971 Release Notes for Firmware Release 9.3(2)SR1
11
Cisco Unified IP Phone 8961, 9951, and 9971 Release Notes for Firmware Release 9.3(2)SR1
Resolved caveats

Cisco 8961 Specifications

General

Resolution	640 x 480 pixels
Display	5-inch TFT color display
Ethernet	10/100/1000 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE) Class 3
Connectivity	Two-port Gigabit Ethernet switch
Buttons	4 softkeys
USB Port	Yes, supports USB 2.0
Headset Jack	Yes, dedicated headset port
Speakerphone	Full-duplex speakerphone
Codec Support	G.711, G.722, G.729, iLBC
Security	802.1X authentication, TLS, SRTP, HTTPS