Cisco ASA 5505

5-1
ASA 5505 Getting Started Guide
78-18003-02
CHAPTER
5
Configuring the Adaptive Security
Appliance
This chapter describes the initial configuration of the adaptive security appliance.
You can perform the configuration steps using either the browser-based Cisco
Adaptive Security Device Manager (ASDM) or the command-line interface
(CLI). The procedures in this chapter describe how to configure the adaptive
security appliance using ASDM.
This chapter includes the following sections:
• About the Factory Default Configuration, page 5-1
• Using the CLI for Configuration, page 5-2
• Using the Adaptive Security Device Manager for Configuration, page 5-3
• Running the ASDM Startup Wizard, page 5-9
• What to Do Next, page 5-10
About the Factory Default Configuration
Cisco adaptive security appliances are shipped with a factory-default configuration
that enables quick startup. The ASA 5505 comes preconfigured with the
following:
• Two VLANs: VLAN 1 and VLAN2
• VLAN 1 has the following properties:
– Named “inside”