Cisco ASA 5505

Chapter 6 Scenario: DMZ Configuration
Configuring the Security Appliance for a DMZ Deployment
6-16
ASA 5505 Getting Started Guide
78-18003-02
Translating Internal Client IP Addresses Between the Inside and DMZ Interfaces
To configure NAT to translate internal client IP addresses between the inside
interface and the DMZ interface, perform the following steps:
Step 1 In the main ASDM window, click the Configuration tool.
Step 2 In the Device List area on the left side of the ASDM window, click Firewall.
Step 3 In the Firewall pane on the left side of the ASDM window, click NAT Rules.
Step 4 Click the green plus (+) icon and choose Add Static NAT Rule.
The Add Static NAT Rule dialog box appears.