Cisco ASR 1006 User Manual

Make certain that the cable-management bracket “U” type feature is facing upwards when you attach it to
the chassis.
Note
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1006 Router in
the rack:
SUMMARY STEPS
1.
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1006 Router.
The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
2.
Using a Phillips screwdriver, insert the screw through the cable-management bracket and into the rack-mount
bracket and then tighten the screw.
3.
Using the bottom rack-mount ear hole, insert the screw through the cable-management bracket and into
the rack-mount bracket.
DETAILED STEPS
Step 1
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1006 Router. The
cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Step 2
Using a Phillips screwdriver, insert the screw through the cable-management bracket and into the rack-mount bracket
and then tighten the screw.
Use a screw from the package of four
screws.
Note
Step 3
Using the bottom rack-mount ear hole, insert the screw through the cable-management bracket and into the rack-mount
bracket.
Cisco ASR 1000 Series Router Hardware Installation Guide
21
Cisco ASR 1006 Router Overview and Installation
Attaching the Cable-Management Brackets

Cisco ASR 1006 Specifications

General

Form Factor	Rack-mountable
Slots	6
Redundancy	Yes
Power Supply	Dual, hot-swappable
Product Type	Router
Memory	Up to 16 GB
Redundant Route Processor	Yes
Product Series	ASR 1000 Series
Model	ASR 1006
Power Supply Options	AC or DC
Operating System	Cisco IOS XE
Rack Units	6U
Rack Height	6U
Interfaces/Ports	Varies by configuration
Flash Memory	8 GB
ESP	Embedded Services Processor
Storage	Internal SSD